Go Back
Keep houseplants safely out of reach with this super simple DIY gold ring hanging planter on the cheap in 20 minutes or less!
Print

Gold Ring Hanging Plant Holder

Keep houseplants safely out of reach with this super simple DIY gold ring hanging planter on the cheap in 20 minutes or less!
Course Crafts
Cuisine Gardening
Keyword Hanging Plant
30 minutes
Total Time 30 minutes
Cost -

Equipment

Ingredients

Instructions

  • Cut 18" of gold floral wire from your paddle. Holding the tail of the wire in place, begin wrapping the wire around itself and the gold hoop.
    Holding the tail of the wire in place, begin wrapping the wire around itself and the gold hoop.
  • Place your smaller ring up against the wire wrap of your larger ring.
    Place your smaller ring up against the wire wrap of your larger ring like seen above.
  • Begin wrapping the wire around the smaller hoop and back over the already wrapped section of the larger.
    Begin wrapping the wire around the smaller hoop and back over the already wrapped section of the larger.
  • Once you have wrapped the 2 hooks together between 0.5-0.75" run the remainder of the wire through the wrap, in between the 2 rings. Trim the excess wire and shove cut end inside of the wrap.
    Once you have wrapped the 2 hooks together between 0.5-0.75" run the remainder of the wire through the wrap, in between the 2 rings.
  • Take your final, large gold ring and place it alongside the smaller ring directly across from the first larger ring. Wrap together as you did the first, trim the excess wire and shove into the wrap.
    Take your final, large gold ring and place it alongside the smaller ring directly across from the first larger ring.
  • Bring your larger rings together and bind them together with gold wire directly in the center of the smaller ring below.
    Bring your larger rings together and bind them together with gold wire directly in the center of the smaller ring below.
  • Finagle the wraps and 3 rings so that it forms a triangle. You should be able to put your pot inside and have it hold snug and level.
    Finagle the wraps and 3 rings so that it forms a triangle. You should be able to put your pot inside and have it hold snug and level.
  • Run an S Hook onto the planter.
    Run an S Hook onto the planter.
  • Remove 2 links from a plant hanging chain. Wrap one link around one of your large rings. Close the link around that ring. Repeat for the other side and bring the 2 large hoops up together.
    Repeat for the other side and bring the 2 large hoops up together.
  • Run an S Hook through the 2 links on the rings, squeezing the S hook with your pliers to securely close around the 2 chains. Add potted plant to the smallest (horizontal) ring and hang.
    Run your S Hook through the 2 links, squeezing the S hook with your pliers to securely close around the 2 chains.