Death Star Ring

May 16, 2015RaChil Luke

I am so late for May the 4th be with you, I know. I was swamped with exams at the time, but now that I’m out of school I finally had time to whip up a DIY in honor of one of my favorite Sci-fi series’!
finaletitled
SUPPLIESSupplies:

  • Silver Sculpey
  • Ring Blank
  • Bake n’ Bond Sculpey Glue
  • Fine black marker
  • Mod Podge
  • X-acto Knife

Step 1: Roll your sculpey into a 1 in. ball. Cut in half.
CUTINHALF

Step 2: Use the backside of the blade to form an a line along the center of the hemisphere.

IMPRINT

MY LATEST VIDEOS
MY LATEST VIDEOS

Use the edge of the blade to carve out a divot in one of your hemispheres. If you mess up, try with the other one. You can always roll everything back together and try again!

DIVOT

Once you’re done with the physical details, put some glue on your ring base and attach!
GLUEIT

Step 3: Bake following the instructions on your package of clay! I baked mine for about 20 minutes.

BAKEIT

Step 4: Once your ring has cooled, use your marker to draw some of the details of the Death Star on.

DETAILS

Seal with a coat of Mod Podge.

PODGEIT
FINALE

Til Next Time!

RaChil

Written by RaChil Luke - Visit Website

Comments (1)

Leave a comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Previous Post Next Post

BEFORE YOU GO!

Sign up for my newsletter and grab my 10 most popular blog posts, I'll send them right to your email address.